YakAttack® MightyMount™ Switch™

With an identical hole pattern as old school deck mounts this mount can be used to switch to a deck mount that accommodates modern track accessories without the need to drill more holes. Compatible with the YakAttack LockNLoad mounting system and with other MightyBolt accessories. For kayaks with pre-threaded inserts, additional hardware may be required.

• Made in the USA

• Locate the red bag of hardware containing nuts, washers and LONG screws and discard them. They will not be used for inflatable kayak installs
• Position the MightyMount Switch on your YakAttack SwitchPad or other inflatable mounts
• Locate the short 1/4-20 x 5/8" long stainless screws in the bag labeled, "Hardware for Inflatable Installs"
• Insert a short screw into each hole of the MightyMount Switch
• Hand tighten with a Phillips Screwdriver until snug. Repeat steps 3 and 4 for the rest of the hardware
• After all screws are installed, fully tighten, being careful not to over tighten

• Locate the Hardware for Deck Mount Installs
• Position the MightyMount Switch on the surface where you want to install it
• Using a hole in the MightyMount Switch as a guide, drill the first hole using a 17/64" drill bit
• Drop a long 1/4‐20 screw through the MightyMount Switch and into the drilled hole. This will prevent the MightyMount Switch from sliding around as other holes are drilled
• Repeat steps 2 and 3 for the rest of the holes
• Once all holes are drilled, remove all screws
• Apply marine sealant as desired into hole and on screw threads
• Install first screw with washer and nut on inside of hull, but do not fully tighten
• Repeat steps 6 and 7 for remainder of screws
• After all screws are installed, fully tighten, being careful not to over tighten

• Please do not use Loctite or a threadlocker that reacts with plastics